Installation Instructions
CE-602-08
The CE-602-08 regulator is designed for use on 2008 and later Dyna models.
Remove Old Regulator
1) Remove the two-¼ 20 cap
head screws that hold the regulator on.
3) Lift the regulator out and
tilt it forward to access the wire connections.
3) Remove the locking clips
and disconnect the stator and battery plugs.
Install New Regulator
1) Remove the retaining clips
from the stator and battery connectors on the new regulator. Save them for
reassembly.
2) Connect the stator and
battery plugs.
3) Install one plug-retaining
clip on each plug.
4) Bolt the regulator in
place using the stock cap head screws.
6) Start the motor and check
battery voltage. Battery voltage should run 14.4 to 14.6 volts.
Have A Good Ride!!
For complete product listing
and technical information see our web site.
REV. 3-10